Click or drag to resize
BrepCreateFromLoftRebuild Method
Constructs one or more Breps by lofting through a set of curves. Input for the loft is simplified by rebuilding to a specified number of control points.

Namespace: Rhino.Geometry
Assembly: RhinoCommon (in RhinoCommon.dll) Version: 5.1.50000.0 (5.0.20693.0)
Syntax
public static Brep[] CreateFromLoftRebuild(
	IEnumerable<Curve> curves,
	Point3d start,
	Point3d end,
	LoftType loftType,
	bool closed,
	int rebuildPointCount
)

Parameters

curves
Type: System.Collections.GenericIEnumerableCurve
The curves to loft through. This function will not perform any curve sorting. You must pass in curves in the order you want them lofted. This function will not adjust the directions of open curves. Use Curve.DoDirectionsMatch and Curve.Reverse to adjust the directions of open curves. This function will not adjust the seams of closed curves. Use Curve.ChangeClosedCurveSeam to adjust the seam of closed curves.
start
Type: Rhino.GeometryPoint3d
Optional starting point of loft. Use Point3d.Unset if you do not want to include a start point.
end
Type: Rhino.GeometryPoint3d
Optional ending point of lost. Use Point3d.Unset if you do not want to include an end point.
loftType
Type: Rhino.GeometryLoftType
type of loft to perform.
closed
Type: SystemBoolean
true if the last curve in this loft should be connected back to the first one.
rebuildPointCount
Type: SystemInt32
A number of points to use while rebuilding the curves. 0 leaves turns this parameter off.

Return Value

Type: Brep
Constructs a closed surface, continuing the surface past the last curve around to the first curve. Available when you have selected three shape curves.
See Also