Click or drag to resize
NurbsSurfaceCreateNetworkSurface Method (IEnumerableCurve, Int32, Int32, IEnumerableCurve, Int32, Int32, Double, Double, Double, Int32)
Builds a surface from an ordered network of curves/edges.

Namespace: Rhino.Geometry
Assembly: RhinoCommon (in RhinoCommon.dll) Version: 5.1.50000.0 (5.0.20693.0)
Syntax
public static NurbsSurface CreateNetworkSurface(
	IEnumerable<Curve> uCurves,
	int uContinuityStart,
	int uContinuityEnd,
	IEnumerable<Curve> vCurves,
	int vContinuityStart,
	int vContinuityEnd,
	double edgeTolerance,
	double interiorTolerance,
	double angleTolerance,
	out int error
)

Parameters

uCurves
Type: System.Collections.GenericIEnumerableCurve
An array, a list or any enumerable set of U curves.
uContinuityStart
Type: SystemInt32
continuity at first U segment, 0 = loose, 1 = pos, 2 = tan, 3 = curvature.
uContinuityEnd
Type: SystemInt32
continuity at last U segment, 0 = loose, 1 = pos, 2 = tan, 3 = curvature.
vCurves
Type: System.Collections.GenericIEnumerableCurve
An array, a list or any enumerable set of V curves.
vContinuityStart
Type: SystemInt32
continuity at first V segment, 0 = loose, 1 = pos, 2 = tan, 3 = curvature.
vContinuityEnd
Type: SystemInt32
continuity at last V segment, 0 = loose, 1 = pos, 2 = tan, 3 = curvature.
edgeTolerance
Type: SystemDouble
tolerance to use along network surface edge.
interiorTolerance
Type: SystemDouble
tolerance to use for the interior curves.
angleTolerance
Type: SystemDouble
angle tolerance to use.
error
Type: SystemInt32
If the NurbsSurface could not be created, the error value describes where the failure occured. 0 = success, 1 = curve sorter failed, 2 = network initializing failed, 3 = failed to build surface, 4 = network surface is not valid.

Return Value

Type: NurbsSurface
A NurbsSurface or null on failure.
See Also