Click or drag to resize

CurveCreateInterpolatedCurve Method (IEnumerablePoint3d, Int32, CurveKnotStyle)

Interpolates a sequence of points. Used by InterpCurve Command This routine works best when degree=3.

Namespace:  Rhino.Geometry
Assembly:  RhinoCommon (in RhinoCommon.dll)
Since: 5.0
public static Curve CreateInterpolatedCurve(
	IEnumerable<Point3d> points,
	int degree,
	CurveKnotStyle knots


Type: System.Collections.GenericIEnumerablePoint3d
Points to interpolate. For periodic curves if the final point is a duplicate of the initial point it is ignored. (Count must be >=2)
Type: SystemInt32
The degree of the curve >=1. Degree must be odd.
Type: Rhino.GeometryCurveKnotStyle
Knot-style to use and specifies if the curve should be periodic.

Return Value

Type: Curve
interpolated curve on success. null on failure.
See Also