Click or drag to resize

MeshingParameters Properties

The MeshingParameters type exposes the following members.

Properties
  NameDescription
Public propertyClosedObjectPostProcess
Gets or sets a value indicating whether or not to post process non-closed meshes that should be closed. If the Brep being meshed is closed, JaggedSeams = false, and ClosedObjectPostProcess = true, and the resulting mesh is not closed, then a post meshing process is applied to find and close gaps in the mesh. Typically the resulting mesh is not closed because the input Brep has a geometric flaw, like loops in trimming curve.
Public propertyStatic memberCode exampleCoarse
Gets mesh creation parameters for coarse meshing.

This corresponds with the "Jagged and Faster" default in Rhino.

Public propertyComputeCurvature
Gets or sets a value indicating whether or not surface curvature data will be embedded in the mesh.
Public propertyStatic memberCode exampleDefault
Gets mesh creation parameters to create the default render mesh. Only use this if you plan on specifying your own custom meshing parameters.
Public propertyStatic memberDefaultAnalysisMesh
Gets mesh creation parameters to create the default analysis mesh.
Public propertyStatic memberFastRenderMesh
Gets mesh creation parameters to create the a render mesh when meshing speed is prefered over mesh quality.
Public propertyGridAmplification
Gets or sets the grid amplification factor. Values lower than 1.0 will decrease the number of initial quads, values higher than 1.0 will increase the number of initial quads.
Public propertyGridAngle
Gets or sets the maximum allowed angle difference (in radians) for a single sampling quad. The angle pertains to the surface normals.
Public propertyGridAspectRatio
Gets or sets the maximum allowed aspect ratio of sampling quads.
Public propertyGridMaxCount
Gets or sets the maximum number of grid quads in the initial sampling grid.
Public propertyGridMinCount
Gets or sets the minimum number of grid quads in the initial sampling grid.
Public propertyJaggedSeams
Gets or sets whether or not the mesh is allowed to have jagged seams. When this flag is set to true, meshes on either side of a Brep Edge will not match up.
Public propertyMaximumEdgeLength
Gets or sets the maximum allowed mesh edge length.
Public propertyStatic memberCode exampleMinimal
Gets minimal meshing parameters.
Public propertyMinimumEdgeLength
Gets or sets the minimum allowed mesh edge length.
Public propertyMinimumTolerance
Gets or sets the minimum tolerance.
Public propertyStatic memberQualityRenderMesh
Gets mesh creation parameters to create the a render mesh when mesh quality is prefered over meshing speed.
Public propertyRefineAngle
Gets or sets the mesh parameter refine angle.
Public propertyRefineGrid
Gets or sets a value indicating whether or not the sampling grid can be refined when certain tolerances are not met.
Public propertyRelativeTolerance
Gets or sets the relative tolerance.
Public propertySimplePlanes
Gets or sets a value indicating whether or not planar areas are allowed to be meshed in a simplified manner.
Public propertyStatic memberCode exampleSmooth
Gets mesh creation parameters for smooth meshing.

This corresponds with the "Smooth and Slower" default in Rhino.

Public propertyTextureRange
Gets or sets how and if textures will be packed.
Public propertyTolerance
Gets or sets the maximum allowed edge deviation. This tolerance is measured between the center of the mesh edge and the surface.
Top
See Also