RhinoCommon documentation has a new look. The old site can still be found here.

/

/

ComponentIndexType

ComponentIndexType enum

Defines enumerated values to represent component index types.

Namespace: Rhino.Geometry
ComponentIndexType: references

Values

InvalidType = 0

Not used. This is the default value of the enumeration type.

BrepVertex = 1

Targets a brep vertex index.

BrepEdge = 2

Targets a brep edge index.

BrepFace = 3

Targets a brep face index.

BrepTrim = 4

Targets a brep trim index.

BrepLoop = 5

Targets a brep loop index.

MeshVertex = 11

Targets a mesh vertex index.

MeshTopologyVertex = 12

Targets a mesh topology vertex index.

MeshTopologyEdge = 13

Targets a mesh topology edge index.

MeshFace = 14

Targets a mesh face index.

MeshNgon = 15

Targets a mesh n-gon index.

InstanceDefinitionPart = 21

Targets an instance definition part index.

PolycurveSegment = 31

Targets a polycurve segment index.

PointCloudPoint = 41

Targets a point cloud point index.

GroupMember = 51

Targets a group member index.

ExtrusionBottomProfile = 61

3d bottom profile curves. Index identifies profile component

ExtrusionTopProfile = 62

3d top profile curves. Index identifies profile component

ExtrusionWallEdge = 63

3d wall edge curve. Index/2: identifies profile component Index%2: 0=start, 1=end

ExtrusionWallSurface = 64

Side wall surfaces. Index identifies profile component

ExtrusionCapSurface = 65

Bottom and top cap surfaces. Index 0=bottom, 1=top

ExtrusionPath = 66

Extrusion path (axis line). Index -1=entire path, 0=start point, 1=endpoint

SubdVertex = 71

Targets a SubD vertex pointer Id. Ids are not guaranteed to be sequential.

SubdEdge = 72

Targets a SubD edge pointer Id. Ids are not guaranteed to be sequential.

SubdFace = 73

Targets a SubD face pointer Id. Ids are not guaranteed to be sequential.

DimLinearPoint = 100

Targets a linear dimension point index.

DimRadialPoint = 101

Targets a radial dimension point index.

DimAngularPoint = 102

Targets an angular dimension point index.

DimOrdinatePoint = 103

Targets an ordinate dimension point index.

DimTextPoint = 104

Targets a text point index.

NoType = 0x0FFFFFFF

Targets no specific type.

Nothing found