RhinoCommon documentation has a new look. The old site can still be found here.

/

/

Cone

Cone struct

Represents the center plane, radius and height values in a right circular cone.

Namespace: Rhino.Geometry
Cone: references

Constructors (1)

Cone(Plane plane, double height, double radius)

Initializes a new cone with a specified base plane, height and radius.

Properties (8)

ApexPoint

Point at tip of the cone.

Axis

Unit vector axis of cone.

BasePoint

Center of base circle.

Height

Gets or sets the height of the circular right cone.

IsValid

True if plane is valid, height is not zero and radius is not zero.

Plane

Gets or sets the base plane of the cone. The apex of the cone is at the plane's origin.

Radius

Gets or sets the radius of the cone.

Unset

Gets an invalid Cone.

Methods (6)

AngleInDegrees()

Computes the angle (in degrees) between the axis and the side of the cone. The angle and the height have the same sign.

AngleInRadians()

Computes the angle (in radians) between the axis and the side of the cone. The angle and the height have the same sign.

EpsilonEquals(Cone other,Double epsilon)

Check that all values in other are within epsilon of the values in this

ToBrep(Boolean capBottom)

Gets a Brep representation of the cone with a single face for the cone, an edge along the cone seam, and vertices at the base and apex ends of this seam edge. The optional cap is a single face with one circular edge starting and ending at the base vertex.

ToNurbsSurface()

Constructs a Nurbs surface representation of this Cone. This is synonymous with calling NurbsSurface.CreateFromCone().

ToRevSurface()

Constructs a RevSurface representation of this Cone. This is synonymous with calling RevSurface.CreateFromCone().

Nothing found