RhinoCommon documentation has a new look. The old site can still be found here.

/

/

QuadRemeshParameters

QuadRemeshParameters class

Parameters for QuadRemesh method

Namespace: Rhino.Geometry
QuadRemeshParameters: references

Constructors (1)

QuadRemeshParameters()

Initializes a new instance of the QuadRemeshParameters class

Properties (8)

AdaptiveQuadCount

Respect the original Target Quad Count value as much as possible. True returns more quads than TargetQuadCount depending on amount of high-curvature areas. Note: this value is ignored when TargetEdgeLength > 0

AdaptiveSize

Larger values results in for quad sizes that adjust to match input curvature. Smaller values results in more uniform quad sizes at the risk of less feature preservation. Range [0 - 100] Note: this value is ignored when TargetEdgeLength > 0

DetectHardEdges

When enabled the hard edges in models will be retained.

GuideCurveInfluence

0 = Approximate 1 = Interpolate Edge Ring 2 = Interpolate Edge Loop This value is ignored if Guide Curves are not supplied

PreserveMeshArrayEdgesMode

0=off, 1=On(Smart), 2=On(Strict) : Mesh array's created from Breps will have their brep face edge boundaries retained. Smart - Small or insignificant input faces are ignored. Strict - All input faces are factored in re-meshed result.

SymmetryAxis

Symmetry axis to use for symmetric re-meshing

TargetEdgeLength

When TargetEdgeLength is greater than 0 TargetQuadCount will be re-computed with the target goal of an approximated edge length based on the area of the input mesh e.g TargetQuadCount = Input mesh Area * sqr(TargetEdgeLength) AdaptiveSize as well as AdaptiveQuadCount will also be ignored;

TargetQuadCount

The number of quads to try to achieve in the final re-meshed object Note: This value is overridden if TargetEdgeLength > 0

Nothing found