RhinoCommon documentation has a new look. The old site can still be found here.

/

/

RibbonOffsetParameters

RibbonOffsetParameters class

Advanced parameters for RibbonOffset Parameters mimic the RibbonOffset Command.

Derived Classes:

Namespace: Rhino.Geometry
RibbonOffsetParameters: references

Constructors (1)

RibbonOffsetParameters()

Initializes a new instance of the RibbonOffsetParameters class

Properties (9)

AlignCrossSections

When false: cross section slashes between input and output curve are located at the ends of ruled spans. When true: cross section slashes between input and output curve are located at the mid points of ruled spans and blends.

BlendRadius

Positive, typically the same as distance. When the offset results in a self-intersection that gets trimmed off at a kink, the kink will be blended out using this radius.

OffsetDistance

Offset curve distance from input curve.

OffsetLocation

Inside or Outside point location

OffsetPlaneVector3d

A vector that indicates the normal of the plane in which the offset will occur. This vector is typically similar to a logical extrude direction for the closed input curve.

OffsetTolerance

Used to determine self-intersections of offset curve, not offset error.

RebuildPointCount

Rebuild offset curve with defined number of control points 0 for disabled

RefitTolerance

Refit the offset curve to a specified tolerance 0 for disabled

RibbonSurfaceGenerationMethod

0 - no surfaces will be created, curves only 1 - Simple Sweep 2 2 - Sweep 2 mixed with NetworkSrf corners

Nothing found