SubDComponentLocation

SubDComponentLocation enum

The ON_SubDComponentLocation enum is used when an ON_SubD component is referenced and it is important to distinguish between the component's location in the SubD control net and its location in the SubD limit surface.

Derived Classes:

Namespace: Rhino.Geometry
SubDComponentLocation: references

Values (3)

Unset = 0

Not a valid component location and used to indicate the value is not initialized. Note well: This value is saved in 3dm archives and cannot be changed.

ControlNet = 1

The component's location in the SubD control net. Note well: This value is saved in 3dm archives and cannot be changed.

Surface = 2

The component's location in the SubD limit surface. Note well: This value is saved in 3dm archives and cannot be changed.

Nothing found